Friday, October 11, 2019

IEC 61076 describes circular connectors with M5 screw-locking


This part of IEC 61076 describes circular connectors with M5 screw-locking, typically used for industrial process measurement and control.


NOTE   M5 is the dimension of the thread of the screw locking mechanism of these circular connectors.

These connectors consist of fixed non-rewirable or rewirable and free connectors non-rewireable.
Male connectors have round contacts 0,48 mm.

1.2      Recommended method of termination

The contact terminations shall be of the following types: screw, crimp, insulation piercing, insulation displacement, press-in or solder.

1. 2.1    Number of contacts or contact cavities

3  and 4 contacts.

1.3      Ratings and characteristics

Rated voltage         3 contacts  60 V d.c. or a.c.

4 contacts  60 V d.c. or a.c.


Current rating
3 contacts  1A

4 contacts  1A
Insulation resistance
: 108 Ω min.
Climatic category
: see 4.1 Table 4
Contact spacing
: see Clause 3

1.4      Normative references

The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

IEC 60050-581, International Electrotechnical Vocabulary – Part 581: Electromechanical components for electronic equipment
IEC 60068-1:1988, Environmental testing – Part 1: General and guidance Amendment 1 (1992)

IEC 60068-2-60:1995, Environmental testing – Part 2: Tests – Test Ke: Flowing mixed gas corrosion test
IEC 60352 (all parts), Solderless connections

IEC 60512 (all parts), Connectors for electronic equipment – Tests and measurements

IEC 60529:1989, Degrees of protection provided by enclosures (IP Code)

Amendment 1 (1999)

IEC 60664-1:2007, Insulation coordination for equipment within  low-voltage systems – Part 1:

Principles, requirements and tests

IEC 60998- 2-1:2002, Connecting devices for low-voltage circuits for household and similar purposes – Part 2-1: Particular requirements for connecting devices as separate entities with screw-type clamping units
IEC 60999 (all parts), Connecting devices – Electrical copper conductors – Safety requirements for screw-type and screwless-type clamping units

IEC 61076-1:2006, Connectors for electronic equipment – Product requirements – Part 1:

Generic Specification

IEC 61984:2001, Connectors – Safety requirements and tests

ISO 1302:2002, Geometrical Product Specifications (GPS) – Indication of surface texture in technical product documentation
1.5      Marking

The marking of the connector and the package shall be in accordance with 2.7 of IEC 61076-1.

No comments:

Post a Comment