Monday, October 14, 2019

The following terms and definitions apply to this standard.

The following terms and definitions apply to this standard.



4.2 circuear Mie (cmie) - the area of a circle with a diameter of 0.001.

4.3 Connector - Device that connects wires to equipment ends or two or more wires.

4.4 Control traverse-non-destructive traverse, including in circulation test loop

4.5 Curling Die - Forming Curling Tool, usually combined with crimping platform, crimping indenter, position regulator.

Note: The crimping die can be separated or include the whole part of the insulating handle, if any.

4.6 Balancer - A bus that provides an equipotential point and equalizes the current in the stranded wire without adversely affecting the connector.

4.7 Packaging Box - The box packed into parts.

4.8 Rated Current (Ampere Rate) - Connector Current set by the manufacturer.

4.9 Connector - Connector set by mechanical pressure between two or more wires, not permanently installed.

4.10 Stability Factor S-Current Cycle Testing Measures Connector Temperature Stability.

4.11 Temperature Rating - Maximum Temperature of Insulated Connector set by Manufacturer.

4.12 Temperature Rise - Indicates the temperature difference of the connector tested under load and ambient temperature conditions.

4.13 Terminal Connector - Connector which is set up by mechanical spinning with one or more wires and terminal plate or double head bolts or similar devices.

4.14 Component Packaging - Minimum Packaging in Connector Packaging.

4.15 Voltage Rating - Maximum Voltage of Insulated Connectors.

5 Symbols and Simplification

5.1-Degree

5.2 A-Ampere

5.3 AI-Al

5.4 AWG-American Line Gauge

5.5 C-Celsius

5.7 Cu-Copper

5.8 D - day

5.9 F - Flexible

5.10 HgNO3-mercury nitrate

5.11 Hz-Hertz cycle per second

5.12 ih-iuch inches

5.13 Kcmil-4 round ears

5.14 m - M

5.15 mil - one thousandth of an inch

5.16 Min-min

5.17 me-ml

5.18 mm-mm

5.19 m2-square millimeter

5.20 N-Newton

5.21 NH4-Ammonia

5.22 gamma-solid and anginated

5.23 gamma pm-revolution per minute

5.24 S - sec

5.25 SAE - Automotive Engineering Association

5.26 SOI - Solid

5.27 STgamma-stranded

5.28 V - V

No comments:

Post a Comment