Low Power Camera Module M5 connector

Low Power Camera Module M5 connector If the sample has not been cycled through the connector and / or terminal of 5.1.7, it is completed.

3. Verify that each sample connector assembly meets the following acceptance criteria. Low power (weak current) circuit resistance test,

Chapter 5.3.1.4. If the test is performed separately. At least 10 pairs of terminals in the sample shall be measured at random.

4. Before the start of the test, the test fixture, system layout and test device must be approved by the authorized person.

5. Place the sample in the temperature chamber where the air flow to the sample will not be hindered and the samples will not touch each other

Put it on Low Power Camera Module M5 connector.

6. Refer to figure 5.1.4 to determine the temperature class that meets the requirements of the specified application of the connector system. Then set the temperature chamber at

At the lowest temperature of the grade. Stabilize the temperature of the temperature chamber before proceeding