USB Camera M20 connector

 USB Camera M20 connector Remove or cut away to make room for slits, collets, and spindles. For clamping and fixing, if necessary, insert the pin

May be shortened. For a given structure, all pin positions should be tested, and in any case

The number of pins should not be less than 10.

1. By "dry as moulded parts", the samples were wet at 95-98% relative humidity and 40 ℃

Then the pull-out test was completed immediately.

2. If possible, the measurement should be carried out in both directions, for example, push the pin longitudinally through the connector, and then pull it out

It's like pulling the socket out of the end plate. In order to get the correct reading, according to personal design, "push" and "pull" should be the same

On the contrary. In a particular design, the connector tail may be properly loaded. For accurate results, the pressure and tension

It must be parallel to the center line of the pin. For pins with curved end plates in the vicinity of short plates, if necessary

The bent end plate can be cut. If it is necessary to cut the pin before applying the force to the test, we should first cut the pin

This will not affect the test results.

3. Fix the connector body in a suitable fixture.

The force tester applies an inclined pressure to the terminal pin. At the beginning of the pin in the plastic sheath or end plate attached

Note and record the forces as they begin to be replaced. Repeat for each pin position. When the connector sheath

When the inevitable damage affects the reading of the adjacent terminal hole, transfer it to an undamaged pin

Or use a new connector.

5. Repeat step 3 by reversing the direction of force according to the sample to be selected