Industrial Electronics M14 cable

Industrial Electronics M14 cable Prepare 20 terminal samples (at least 10 plug terminals and 10 socket terminals) according to the terminal sample preparation in section 5.1.6

The maximum size conductor and insulation thickness suitable for the tested terminal shall be used.

2. If the sample has not been cycled for connectors and / or terminals in 5.1.7, complete it.

3. For the purpose of this test, the plug terminal must be inserted into the socket terminal at a precise depth. The standard operation method is: Press

According to figure 5.3.1.4., in the worstcase, the rear contact point of the socket terminal and the

There must be at least 1 mm over insertion between all guide cones. As shown in figure 5.3.1.4. This size is authorized by

It is calculated based on the terminal diagram, taking into account the worst-case tolerance. Must be in each plug。